Econo Flag Setup Instructions

 

1. Open the four bars that are part of the hardware

2.Connect the poles together, smallest to largest. There will be a slight notch on the top piece to connect the other pole to.

3. After all poles have been connected, slip the printed flag over the top of the pole.

4. Keep sliding it all the way down to the bottom of the pole.





5. Once attached, we need to connect the bungee cord to the flag to hold it in place. 6. Slide the bungee cord through the small loop at the bottom of the flag print. 7. Then slide it back through the clip on the pole, and pull it tightly. 8. You can tie it off at this point to secure it.




9. It should look like this when completed. 10. Your flag is ready to be placed in the location you desire.